Cat S62 Six Bay Drop-In Charger

AdvanceTec’s 6 Bay Cat S62 Phone Charger is designed to support up to six phones at a time. Simply snap the phone into the custom pocket to charge according to manufacturer’s specifications. The LED indicator will turn from BLINKING green to SOLID green when charge complete.

FEATURES

  • Charge up to 6 phones at 2.0 Amp each
  • Use as desktop
  • Eliminates the need to plug-in charging cables
  • Weight 15 lbs.
  • Dimensions 10.40” x 6.57” x 18.11” (W x H x D)
  • Input voltage 110/220 VAC
  • Heavy-duty, robust aluminum construction withstands rugged use

DON’T BLAME THE BATTERY…
Before you contact your communications supplier to purchase a replacement battery, consider this: today’s high-quality nickel cadmium (Ni-Cd), nickel metal hydride (Ni-MH) and Lithium Ion (Li-Ion) batteries are only as effective as the chargers on which they are placed at the end of the day. Not all chargers are the same and different chemistry batteries need to be charged differently.

There are 2 very important aspects to the charging of a battery that inevitably will determine how long it will last after the charge and how long it will last before it drops below an acceptable level:

  • The method used to charge the battery
  • The method used to terminate the charge

AdvanceTec’s Li-Ion Specific Chargers
Li-Ion batteries are lighter than other energy-equivalent secondary batteries, including both Ni-Cd and Ni-MH. However high charge levels and elevated temperatures from charging will hasten capacity loss. If overheated or overcharged, Li-ion batteries may suffer thermal runaway and cell rupture. In extreme cases this can lead to combustion. Deep discharge may short-circuit the cell, in which case recharging would be unsafe. The AdvanceTec™ Li-Ion charger makes use of VSCTM™ (Voltage Specific Control) when charging Li-Ion and Li-Poly chemistry batteries. The discharge pulse has a relaxing effect on the battery, increasing charge acceptance and allowing a charge at a lower temperature. Current is applied until the voltage limit per cell (as recommended by the cell manufacturer) is reached and then the precise voltage per cell limit (±.2%) is applied until the current declines below 3% of rated charge current. If voltage is applied exceeding the recommended voltage, it will cause a rapid and permanent reduction in the number of cycles in the battery.